National Instruments NI 5911 Graphics Tablet User Manual


 
Glossary
© National Instruments Corporation G-3 NI 5911 User Manual
clock hardware component that controls timing for reading from or writing to
groups
CMRR common-mode rejection ratioa measure of an instruments ability to
reject interference from a common-mode signal, usually expressed in
decibels (dB)
counter/timer a circuit that counts external pulses or clock pulses (timing)
coupling the manner in which a signal is connected from one location to another
D
dB decibelthe unit for expressing a logarithmic measure of the ratio of
two signal levels: dB=20log10 V1/V2, for signals in volts
DC direct current
default setting a default parameter value recorded in the driver. In many cases, the default
input of a control is a certain value (often 0) that means use the current
default setting.
device a plug-in data acquisition board, card, or pad. The NI 5911 is an example
of a device.
differential input an analog input consisting oftwo terminals, both of which are isolated from
computer ground, whose difference is measured
double insulated a device that contains the necessary insulating structures to provide electric
shock protection without the requirement of a safety ground connection
drivers software that controls a specific hardware instrument
E
EEPROM electrically erasable programmable read-only memoryROM that can be
erased with an electrical signal and reprogrammed
equivalent time
sampling
anymethod used tosample signals insuch a waythat the apparent sampling
rate is higher than the real sampling rate
event the condition or state of an analog or digital signal