Filter
Top Products
NCR RealScan 7882 Installation and Owner Guide
497-0419630 Release F 09/02
17 of 62
Making Other Program Changes
If you still need to make program changes after setting the communication parameters,
you can enter information directly from the Programming Worksheets. The
Programming Worksheets, located at the back of this book, identify all the available
program parameters. Each worksheet relates to a specific programming mode. Most
programming options have defaults, identified by a heavy box, that are determined at
the factory. Scanning the Default tag as the first tag after applying power to the
RealScan 7882 sets the parameters to these values.
Changing the RealScan 7882 program is accomplished by scanning the proper
sequence of programming tags. Following are three major steps for making program
changes.
1.
Enter the Base Programming State by scanning the Programming Mode tag as the
first tag after applying power to the RealScan 7882.
2.
Select a Programming Worksheet and enter its parameter data by scanning the
appropriate Hex tags.
3.
Save the program by scanning the Save and Reset tag.
Note: In most instances the factory determined defaults are the correct parameter
setting. However, if you do need to make changes, it is recommended that you first set
all parameters to default values, then make any necessary changes to the appropriate
parameters.