Filter
Top Products
Figure 22. New/Edit Address
Two levels of access may be assigned.
Read
Read-only rights. The user may read everything
except the Access Control settings, but cannot
alter anything
Read/Write The user may read and alter all settings
Enter your IP address and then set your own access rights to Read/Write (see the
following note).
Note: Do not set all the stations in the Access Control table to Read. Once this is
set and enabled, it will be impossible to modify the AP settings via IWMS.
Should this situation occur, press the hardware Reset Button to restore the
factory configuration.
To set a stations access rights, enter a station’s IP address and community string
(the community string is used as a password to access the WWB or WEC) and
choose Read or Read/Write.
InstantWave 11Mbps
WWB/WEC
42