Filter
Top Products
Status, Error, and Service Messages
103
PUT <
X
> IN INPUT
<
Y
>
The <
X
> specified media
is not in the input tray
<
Y
>.
Refill the tray with the
specified type media.
PUT <
SIZE>
PAPER
IN <
INPUTBIN>
BIN
The Operator Control/
Chain Inputbins is set to
Off and the displayed
tray is empty. Refill it
with the specified size
media. <
SIZE>
is the
media size detected by
the engine, and
<
INPUTBIN>
is the
empty tray.
Refill the tray with the
specified size media.
PUT THICK STOCK IN
INPUT BIN
Thick stock has been
specified in the Opera-
tor Control/Media/For
Upper Bin control panel
setting.
Refill the tray with thick
stock or change the
control panel setting
from Thick Stock to
Automatic.
PUT TTRANSPARENCY
IN INPUT BIN
Transparency has been
specified in the Opera-
tor Control/Media/For
Upper Bin control panel
setting.
Refill the tray with trans-
parencies or change the
control panel setting
from Thick Stock to
Automatic.
PUT <
TYPE
MEDIA>
IN INPUT BIN
Operator Control/Chain
Inputbins is set to On
and a chained tray is
empty.
Refill the tray with the
specified type media.
REAR DOOR OPEN The rear cover is not
closed.
Close the rear cover.
REPLACE <
X
> The specified item <
X
>
needs to be replaced,
such as the OPC drum.
Replace the specified
item.
RESETTING
ACCOUNTING
The reset accounting
operation is in process.
No action needed.
TOP DOOR OPEN The top cover of the
printer is not fully closed.
Make sure the top cover
is fully closed.
This message... means... do this...