Filter
Top Products
ND-91649(E) CHAPTER 5
Page 43
SPECIFICATIONS
Table 5-1 System Capacity (Single MP System) (Cont’d)
System Capacity
Item
1PIM 2PIM 3PIM 4PIM 5PIM 6PIM 7PIM 8PIM
Attendant Terminal (D
term
ATT Position) Max. 8 sets per system
SMDR Interface Max. 1 interface port per system
PMS Interface Max. 1 interface port per system
ACD / MIS or OAI Interface Note 8
Max. 1 interface port per system
Remote PIM over IP (Number of PIM at Remote Site) 20 (depending on network configurations)
DID Dial Conversion 1000
Call Forwarding-Outside Set 496
Authorization. Code / Forced Account Code / Remote Access
to System (DISA) Code
3000
Message Remainder Set 1024
Name Display / Guest Name Display 512
Speed Calling-Station (Station Speed Dial) Set 10000
MP built-in SMDR Call Record 1280
Note 1: The total number of trunk line and DTI channel shall be 256 or less.
(Each trunk line and DTI channel are required to assign the “Trunk Number” by system data
programming and maximum number of system parameter for “Trunk Number” is 256.)
Note 2: “PIM” in this table means “Physical PIM.”
Note 3: Maximum number of voice channels per IP PAD card depends on the payload size as follows.
32IPLA+16VCTA
Maximum Voice Channels per IP PAD (32IPLA+16VCTA)
Payload Size
G.711 G.729a G.723.1
10ms 12 12 -
20ms 20 20 -
30ms 30 30 24
40ms 32 32 -
8IPLA+24IPLA
Maximum Voice Channels per IP PAD (8IPLA+24IPLA)
Payload Size
G.711 G.729a G.723.1
10ms 20 20 -
20ms 32 32 -
30ms 32 32 24
40ms 32 32 -