Filter
Top Products
Quick Start cont.Start
4
4. Connect one end of the power cord to the MultiSync
®
FP Series monitor and the other
end to the power outlet (Figure D.1).
5. Turn on the monitor (Figure E.1) and the computer.
6. The Factory Setting for your monitor is set for D-SUB installation. If you are using a
BNC cable connection, push the BNC/D-SUB button on the front of the monitor
(Figure E.1) to switch settings.
Power
Cord
Power Outlet
Figure E.1
Figure C.1
Figure D.1
RESET BNC/D-SUBPROCEEDEXIT
MultiSync
Power Button
BNC/D-SUB
BNC
Connector
R
G(/Sync)
B
VS
HS/CS
NOTE: For download information on the Windows
®
95/98 INF file for your MultiSync FP
Series
monitor, refer to the References section of this user’s manual.
NOTE: If you have any problems, please refer to the Troubleshooting section of
this User’s Manual.
Figure B.2Figure A.2
78134171 12/3/98, 4:10 PM6