Filter
Top Products
461
CHAPTER 19 SERIAL INTERFACE CHANNEL 2
(2) Communication operation
(a) Data format
The transmit/receive data format is as shown in Figure 19-7.
Figure 19-7. Asynchronous Serial Interface Transmit/Receive Data Format
One data frame consists of the following bits.
• Start bits.................. 1 bit
• Character bits ......... 7 bits/8 bits
• Parity bits ................ Even parity/odd parity/0 parity/no parity
• Stop bit(s) ............... 1 bit/2 bits
The character bit length, parity, and stop bit length for each data frame are specified with asynchronous
serial interfaece mode register (ASIM).
When 7 bits are selected as the number of character bits, only the lower 7 bits (bits 0 to 6) are valid; in
transmission the most significant bit (bit 7) is ignored, and in reception the most significant bit (bit 7) is
always "0".
The serial transfer rate is set with ASIM and the baud rate generator control register (BRGC).
If a serial data receive error is generated, the receive error contents can be determined by reading the
status of the asynchronous serial interface status register (ASIS).
D0 D1 D2 D3 D4 D5 D6 D7
Parity
Bit
Stop Bit
Start
Bit
One Data Frame
Character Bits