Filter
Top Products
16
2. INSTALLATION
Selecting A Location
The further your projector is from the screen or wall, the larger the image. The minimum size the image can be
projected is 80" (2 m) measured diagonally. The largest the image can be is 500" (12.7 m).
WARNING
• Only use your projector on a solid, level surface. If the projector falls to the ground, you can be injured and
the projector severely damaged.
• Do not use the projector where temperatures vary greatly. The projector must be used at temperatures
between 32 degrees F (0 degree C) and 104 degrees F (40 degree C).
• Do not expose the projector to moisture, dust, or smoke. This will harm the screen image.
• Ensure that you have adequate ventilation around your projector so heat can dissipate. Do not cover the
vents on the bottom or back of the projector.
Screen Size and Projection Distance
1. Place your projector on a flat level surface at
the optimal distance from the screen or wall so
you realize the size image you want. (Avoid
having bright room lighting or sun light
directly on the screen or wall where you’ll be
projecting the image.)
2. Connect the power cable, remove the lens cap
and turn the projector on. (If no input signal is
available, the projector will display a black
screen.)
3. Ensure that the projector is square to the
screen.
4. Move the projector left or right to center the
image horizontally on the screen.
Pulling Out the Handles
Pull out the handle from the bottom side.
Retracting the Handles
Press down the two levers at the same time to retract the
handle.
Setting Up Your MultiSync Hivid 3500 Projector
To set up and use your MultiSync Hivid 3500 Projector, you
must first do:
1. Determine the screen size and the optional lens to be used.
NOTE: Consult your dealer for lens order and installation.
2. Set up a screen or select a non-glossy white wall onto
which you can project your image.
Moving The Projector
Always carry your projector by the handle. Ensure that the
power cord and any other cables connecting to video sources
are disconnected before moving the projector. When moving
the projector or when it is not in use, cover the lens with the
lens cap.
This section describes how to set up your MultiSync Hivid 3500 projector and how to connect video and audio sources.
Projector
Screen
Lens center
Screen center
Projector
Screen