Filter
Top Products
Max 410/420/430 User’s Guide – Chapter 3
27
Figure 7 – HyperTerminal Window (Enter IP Address)
3. When you finish making changes, reset the Max
410 to activate the changes. You may either:
type /system/reset at the command
line, or
power-off the unit, wait 10 seconds, and
turn it on again.
4. (Optional) Ping the Max from a PC, as illustrated
below, using the new IP address, to confirm that
the correct parameters have been entered and
stored successfully.
Figure 8 – Pinging the Max
The new IP address and netmask are now in effect. If you
are using static IP addresses, you are now ready to finish
setting up the Max 410 using the Max Web Manager.
Proceed to Chapter 4, Logging In to the Max Web
Manager.