www.netcomm.com.au Rev.1 - YML658
Page 32 AM5698 Roadster V.92 User Guide
Regulatory Information
Austel Requirements
(Australia Only)
The software supplied with this modem has
default settings compliant with the
requirements of Austel Technical Standard
TS-ØØ2.
Adjustment of these settings outside the
required limits will void the Austel permit
associated with the modem.
Dial Retry Attempts
With the service tone detection enabled (eg.
Busy Tone) the unit must not be configured to
make more than 1Ø dial attempts to the same
telephone number.
With the service tone detection disabled (eg.
Busy Tone - ATXØ) the unit must not be
configured to make more than 3 dial attempts
to the same telephone number.
With dial tone detection disabled (eg. ATXØ)
the unit should be configured to dial not less
than two seconds after line seizure and not
more than 5 seconds after line seizure.
In all of the above cases no further attempts
shall be made to connect to the telephone
number, until a further period of at least 3Ø
minutes has elapsed (this does not apply if
the redial sequence is manually restarted).
Call Answering
The modem shall answer an incoming call by
seizing the line in not less than 2 seconds
from the start of the application of ring signal
from the PSTN. (eg. ATSØ=2 or issue ATA
after the 2nd ring.)
Internal Modems Internal modems are
designed to operate only within a PC with a
screw down lid.
Also, telecommunications network voltages
exist on the card inside the PC. Therefore the
telecommunications line connection (Telecom
cable) must be removed before opening the
case of the PC. NOTE Adjustment of these
settings outside the required limits will void the
Austel permit associated with the modem.
Connection of a non-approved modem to the
telecommunications network is an offence
under Section 253 of the Telecommunications
Act 1991 and may attract a maximum fine of
$12,ØØØ.