Filter
Top Products
NB712 / NB714 User Guide 101
YML829 Rev1
14.16.7 Route
You can setup the routing parameters in route command. If the product is configured as a bridge, you do not want
to setup the route parameters. Move the cursor “ >> “ to route and press enter.
>> static Configure static routing table
rip Configure RIP tool
If the Router is connected to more than one network, it may be necessary to set up a static route between them. A
static route is a pre-determined pathway that network information must travel to reach a specific host or network.
With Dynamic Routing, you can enable the Router to automatically adjust to physical changes in the network’s
layout. The Cable/DSL Firewall Router, using the RIP protocol, determines the network packets’ route based on
the least number of hops between the source and the destination. The RIP protocol regularly broadcasts routing
information to other routers on the network.
You can setup 20 sets of static route in static command. After entering static menu, the screen will show as
follow:
>> add Add static route entry
delete Delete static route entry
list Show static routing table
You can add 20 sets of static route entry by using add command. Type the IP information of the static route
including IP address, subnet mask and gateway.
You can delete the static route information via delete command.
You can review the static route entry by using list command.
To configure Routing Information Protocol (RIP), you can use rip command to setup the parameters. Move the
cursor “>>” to rip and press enter.
>> generic Configure operation and auto summery mode
lan Configure LAN interface RIP parameters
wan Configure WAN interface RIP parameters
list Show RIP configuration
Generic command can setup RIP mode and auto summery mode.
If there are any routers in your LAN, you can configure LAN interface RIP parameters via lan command.
The product supports 8 PVCs and you can configure the RIP parameters of each WAN via wan command. Move
the cursor “>>” to wan and press enter.
----------------------------------------------------------------------
Command: setup route rip wan <1~8> <more...>
Message: Please input the following information.
Active interface number <1~8>: 1
----------------------------------------------------------------------
The screen will display the following:
>> attrib Operation, authentication and Poison reverse mode
version RIP protocol version
authe Authentication code
Attrib command can configure RIP mode, authentication type and
Poison reverse mode.
Version command can configure RIP protocol version.
Authe command can configure authentication code.
You can review the list of RIP parameters via list command.