Filter
Top Products
V200 VoIP Telephone Adaptor/Router 11
YML796 Rev1
1.8 Back Panel and Wiring
Label Description
Reset Press button to restore the configuration to its factory
state.
WAN Connect to your ADSL modem LAN port with an
RJ45 connector cable.
Phone 1 ~ 2 Connect to one or two phones with an RJ11
connector cable.
LAN Connect to your PCs (Ethernet ports) or a hub/switch
with RJ45 connector cables.
Power Connect to the power adapter and then plug the
power adapter into the wall outlet.
1.9 Power-up, Boot and Reset
Please only power up your V200 after all cables are connected. The POWER LED should
always be on after the V200 has powered up. Once the power is on, the V200 will boot up
automatically. Do not do anything until the boot up process has completed.
Boot or reboot
During the booting period, all of the LEDs, except for the POWER LED, will flash
irregularly. This is part of the normal process. All LEDs should be stabilized after the V200
has completely booted up (on, off or regular flashing). The whole booting procedure takes
about 1.5 minutes. Do not do anything to the V200 during the boot up, as this may cause
unexpected results or even damage the V200.
Reset
Reset reloads the V200 to its factory default settings. After the V200 has completely booted
up, use a small object - like a ballpoint pen to press the button and hold it down for over
three seconds. The V200 will reset and all its parameters will return to their factory default
settings. Then the V200 will reboot automatically. You can also reset the V200 in the Reset
menu of its Web configuration page.