Filter
Top Products
Reference Manual for the RangeMax Wireless Router WPN824
4-8 Wireless Configuration
202-10072-01, March 2005
Default Factory Settings
When you first receive your WPN824, the default factory settings are shown below. You can
restore these defaults with the Factory Default Restore button on the rear panel. After you install
the WPN824 router, use the procedures below to customize any of the settings to better meet your
networking needs.
How to Set Up and Test Basic Wireless Connectivity
Follow the instructions below to set up and test basic wireless connectivity. Once you have
established basic wireless connectivity, you can enable security settings appropriate to your needs.
1. Log in to the WPN824 firewall at its default LAN address of http://www.routerlogin.net (or
http://192.168.1.1) with its default user name of admin and default password of password, or
using whatever LAN address and password you have set up.
FEATURE DEFAULT FACTORY SETTINGS
Wireless Access Point Enabled
Wireless Access List (MAC Filtering) All wireless stations allowed
SSID broadcast Enabled
SSID NETGEAR
11b/g RF Channel 6
Mode Auto 108
Authentication Type Automatic
WEP Disabled
DHCP Server Enabled
DHCP range 192.168.1.2 to 192.168.1.254
Note: If you use a wireless computer to configure WPA settings, you will be
disconnected when you click Apply. Reconfigure your wireless adapter to match the
new settings or access the wireless router from a wired computer to make any further
changes.