Filter
Top Products
Reference Manual for the RangeMax Wireless Router WPN824
Advanced Configuration of the Router 8-3
202-10072-01, March 2005
Wireless Card Access List
The Wireless Card Access Setup page displays a list of wireless PCs that will be allowed to
connect to the router based on their MAC addresses. These wireless PCs must also have the correct
SSID and WEP settings configured on the Wireless Settings page to access the wireless network.
From the Wireless Settings menu, click the Setup Access List button to display the Wireless
Access List menu:
Figure 8-2: Wireless Card Access List screen
Program the wireless card access list as follows:
• Turn Access Control On
a. Click the check box to Turn Access Control On and enable the restricting of wireless PCs
by their MAC addresses.
b. Click the Apply button to save changes and return to the Wireless Settings page.
Note: If Turn Access Control On is enabled and the Access Control List is blank; then all
wireless PCs will be unable to connect to your wireless network.
• To Set Up The Access Control List:
a. Click the Add button to go to the Access Setup menu (see Figure 8-3). This menu displays
a list of currently active wireless cards and their Ethernet MAC addresses.
b. If the desired PC appears in the list, you can click the radio button of that PC to capture its
MAC address; otherwise, you can manually enter the MAC address of the authorized PC.
The MAC address can usually be found on the bottom of the wireless device.
c. If no Device Name appears, you can type a descriptive name for the PC that you are
adding.