Filter
Top Products
Reference Manual for the RangeMax 240 Wireless Router WPNT834
4-8 Wireless Configuration
v1.0, November 2005
Default Factory Settings
When you first receive your WPNT834, the default factory settings are in effect, as shown below.
You can restore these defaults with the Factory Default Restore button on the rear panel. After you
install the WPNT834 router, use the procedures below to customize any of the settings to better
meet your networking needs.
How to Set Up and Test Basic Wireless Connectivity
Follow the instructions below to set up and test basic wireless connectivity. Once you have
established basic wireless connectivity, you can enable security settings appropriate to your needs.
1. Log in to the WPNT834 firewall at its default LAN address of http://www.routerlogin.net (or
http://192.168.1.1) with its default user name of admin and default password of password, or
using whatever LAN address and password you have set up.
FEATURE DEFAULT FACTORY SETTINGS
Wireless Router Radio Enabled
Wireless Access List (MAC Filtering) All wireless stations allowed
SSID broadcast Enabled
SSID NETGEAR
802.11b/g RF Channel 11
Mode Auto 108
Authentication Type Automatic
WEP Disabled
DHCP Server Enabled
DHCP range 192.168.1.2 to 192.168.1.254
Note: If you use a wireless computer to configure WPA settings, you will be disconnected
when you click Apply. Reconfigure your wireless adapter to match the new
settings or access the wireless router from a wired computer to make any further
changes.