Filter
Top Products
Installation Guide for Customer Self Install, Windows 9x/ME/NT/2000/Mac Page 18
2002 MegaPath Networks Inc. All rights reserved.
4. Highlight Internet Protocol (TCP/IP) and click on the Properties button. If you do not see TCP/IP in the list, go to
the section in this guide titled Installing TCP/IP.
5. Click Use the following IP address. Enter in your static IP address, Subnet Mask, and Gateway as shown
below.
1. Move your cursor to the
“IP address” dialog box
and enter 192.168.1.2.
2. Move your cursor to the
“Subnet mask” box and
enter 255.255.255.0.
3. Move your cursor to the
“Default gateway” box
and enter 192.168.1.1.
Click here.
6. Click OK. Click OK twice to close the last two screens and click Close to close the last screen. Under most
circumstances, Windows 2000 will not require a reboot. If it does, please do so. If you have multiple computers,
use the same subnet mask number and different IP addresses for each computer.
192.168.1.3 - second computer.
192.168.1.4 - third computer
192 .168.1.5 - fourth computer
7. Click OK. To check for the success of your setup, open a web browser and visit www.megapath.net. While there,
you will find more information about services as well as setup and other support information.