Filter
Top Products
12
- remove protective cap (8, Fig. 1) from emitter tube
output window;
- activate LAM in mode C;
- match the center of radiation spot with the aiming mark
by means of rotating handwheels of adjustment
mechanisms;
- perform test firing with LAM under the same conditions
as when checking the weapon fire capability with an iron
sight;
- eliminate deviation of the center of impact from the
aiming mark. Deviation is measured by adjustment steps:
each click of adjustment mechanism corresponds to the
shift of radiation spot by 50 mm, when firing at the target
situated at a distance of 100 m, i.e. 0.5 mrad;
- fire again after introducing adjustments;
- cover emitter tube output window with protective cap (8,
Fig.1).
After adjusted LAM is remounted on the same Picatinny rail
of the same weapon new re-adjustment is not required.
When firing at a distance to which the weapon with LAM
was zeroed, aiming should be performed by pointing
radiation spot at the target. When firing at other distances,
aiming should be performed in accordance with the table of
exceeding the average bullet trajectories above the line of
sight.