Filter
Top Products
UPS/400 . . . an IBM AS/400 UPS power monitoring system . . .
3
Stage 4: System Restore and Follow-up Monitoring
• If power is returned, all active users are notified and the system is fully restored to its original active
state.
• Remaining battery power is monitored by the system administrator through a UPS current status
display which visually depicts remaining battery life by means of a “battery life line.”
These stages should not be confused with the six staged intervals used during actual UPS/400 shutdown
processing.
USER-CONTROLLED SHUTDOWN PROCEDURES AND MESSAGES
You may define UPS/400 shutdown procedures using the System Attributes display. This display is used to
specify the actions to be taken at the six intervals, including Job Queues to be held, Sub-Systems to end,
and the severity level of the message to be issued. A complete description of this display and its options
are shown on the following pages.
The current UPS Status display can be used to monitor remaining battery life during and after shutdown
procedure. The following page shows a flowchart of UPS/400 shutdown activities.
TECHNICAL SUPPORT
For direct technical support on UPS/400 call … (918) 587-1500
Faxes may be sent to …………………………… (918) 587-1536
Modem dial-in for PTF’s and Updates ………… (918) 587-6923