Nokia 930C Computer Monitor User Manual


 
E
N
G
L
I
S
H
4 Nokia 930C
Quick Installation
1 Connect video cable(s)
Make sure both the monitor and computer
are powered OFF.
The monitor can be connected to one or two
computers using either the DB-15 video
cable (included) or a BNC video cable
(purchased separately). Totoggle between
two computers: connect the DB-15 video
cable to the monitor and first computer, and
then connect the BNC video cable to the
monitor and the second computer.
Macintosh users: Models older than G3
require a Macintosh adapter. Attach the
adapter to thecomputer and plug the video
cable into the adapter.
To order a Macintosh adapter, contact your
dealer. See Customer Support in this user
guide.
2 Connect power cord
Connect thepower cord from themonitor to
a properly grounded AC outlet.
3 Power-ON monitor and computer
Power-ON the monitor, then power-ON the
computer. This sequence (monitor before
computer) is very important.
NOTE:At thispoint Windows98 users may
receive a message asking them to install the
930C INF file.
4 Install INF and ICM files
For CD-ROM: Insert the CD-ROM into the
CD-ROM drive, select “MonitorDrivers,”
and follow the on-screen instructions.
For diskette
: Insert your diskette into the
diskettedriveandrun install.exe. Followthe
on-screen instructions.
5 Windows users: Set the Timing
Mode (resolution and refresh rate)
Example: 1600 X 1200 @ 85 Hz.
Forinstructions on changing the resolution
and refresh rate, see the userguide for your
computer's graphics card.
Installation is complete. Enjoy your new
930C monitor!
To be best prepared for any future customer
service needs:
Write the serial number (see back of the
monitor) in “For your Records” on page 1
of this guide.
Ports for optional
BNC video cable
Video cable
to computer
Power cords