Filter
Top Products
Installing and Operating Passport ARN Routers
A-8
114200-E Rev 00
Examples of bconfig Commands
1. Configure the default netboot procedure. Use a local image file and look for
the configuration file over the network using BootP.
bconfig -d image
(or
bconfig image local
)
bconfig -d config
(or
bconfig config network
)
2. Use netboot for both the image file and the configuration file.
bconfig image network
bconfig config network
3. Use a local configuration file and use directed netboot for the software image
file.
bconfig image network 21.3.5.62 /usr/mykernel.exe
bconfig config local
4. Use a local software image file and use directed netboot for the configuration
file.
bconfig image local
bconfig config network 21.3.5.62 /usr/arnstartup/config
5. Use directed netboot for both the software image file and the configuration
file.
bconfig image network 21.3.5.62 /usr/mykernel.exe
bconfig config network 21.3.5.62 /usr/arnstartup/config
Verifying Your Configuration
You can use the get configuration command
getcfg
to verify:
• Whether the router is set to boot using a local or remote software image
• Whether the router is set to configure using a local or remote configuration
file
• The configuration of any serial, DSU/CSU, Ethernet, and token ring
connectors
To display the ARN startup options, enter the following command:
getcfg