Filter
Top Products
SNMP for ERS 8600 TCG v2.1 NN48500-564
Nortel Confidential Information Copyright © 2008 Nortel Networks. All Rights Reserved.
External Distribution
11
d) Add the usm group ‘group_example’ to policy 2:
• ERS-8610:5# config sys access-policy policy 2 snmp-group-add group_example
usm
e) Enable access strict enable
• ERS-8610:5# config sys access-policy policy 2 access-strict true
f) Enable telnet and SNMPv3 service:
• ERS-8610:5# config sys access-policy policy 2 service telnet enable
• ERS-8610:5# config sys access-policy policy 2 service snmpv3 enable
g) Enable policy 2:
• ERS-8610:5# config sys access-policy policy 2 enable
h) After the policy has been created, enter the following command to view policy 2:
• ERS-8606:5# show sys access-policy info policy2
AccessPolicyEnable: on
Id: 2
Name: policy2
PolicyEnable: true
Mode: allow
Service: telnet|snmpv3
Precedence: 10
NetAddr: 0.0.0.0
NetMask: 0.0.0.0
TrustedHostAddr: 0.0.0.0
TrustedHostUserName: none
AccessLevel: readWriteAll
AccessStrict: true
Usage: 3777
• ERS-8610:5# show sys access-policy snmp-group-info
snmpv3-groups :
Policy 1 snmpv3-groups :
Group Name Snmp-Model
Policy 2 snmpv3-groups :
Group Name Snmp-Model
group_example usm
3.3.2 SNMPv1/2 Group Access Policy: Configuration Example
As release 3.7 and 4.1 is based on the SNMPv3, you must add the SNMPv3 group name and
model for both SNMPv1 and SNMPv2 when setting up an access policy. To view the SNMPv3
group name and model, please use the following as shown below. Note that the items high-
lighted in red need to be added when setting up the access policy.
• ERS8610-B:5# show snmp-v3 group-access