Filter
Top Products
78 Digital Telephone IP Adapter Installation and Administration Guide
Installing the Digital Telephone IP Adapter unit Standard 2.1
Complete the following procedure:
1 Choose the location on the wall where you want to mount the Digital
Telephone External IP Adapter unit.
2 Use the pre-drilled screw slots on the bottom of the Digital Telephone
External IP Adapter unit as a guide to measure and mark the location on
the wall for each mounting screw.
The measurements between the screw slots are as follows:
! from front to back panels: 2.54 cm (1 in.)
! from side to side: 15.8 cm (6.25 in.)
3 Mount the screws.
Note: Do not screw the screws all the way in. Stop when the heads are
about 5 mm (1/8 inch) from the wall.
4 Mount the Digital Telephone External IP Adapter unit on the screws, then
gently pull it down so the screws slide into the narrow portion of the screw
slots.
Note: Do not let go yet.
5 Make sure that the Digital Telephone External IP Adapter unit is securely
mounted.
.
WARNING
Risk of equipment damage
Ensure that you fasten the Digital Telephone External IP Adapter
unit securely to the wall. Falls can damage the unit.