Filter
Top Products
30 Linux base and applications installation and upgrade task flow
Step Action
There are no prerequisites for this procedure.
1 Open a command line interface session to the Primary ECM
Security Server through the serial port with the nortel account.
2 Switch user to the root account by typing SU and press <enter>.
3 Enter the root user password when prompted.
4 Execute the following script:
/opt/nortel/isclient/setup_ssha.sh deconfig
5 If a Backup ECM Security server is present in the system, switch
user to the root account and execute the script
/opt/nortel/isclient/failOver.sh <FQDN of Primary
ECM Security Server>
where <FQDN of Primary ECM Security Server> is set to the
FQDN of the Primary ECM Security server.
6 Wait for two minutes after the command completes before
proceeding.
7 Switch user back to the nortel account by typing exit.
8 Perform the “Upgrading Nortel Linux base ” (page 54) procedure.
9 Open a command line interface session to the Primary ECM
Security Server through the serial port with the nortel account.
10 Install the following patches onto the Primary ECM Security
server using the “Patching Operation” (page 106) procedure.
• MPLR25520
• MPLR25521
--End--
This procedure describes upgrading the Primary ECM Security server from
Rls 5.00 to Rls 5.50 in a configuration with a Backup ECM server and
three or more Member servers associated with it.
1c: Upgrade Primary server with Backup server and three or more Member
servers
Step Action
There are no prerequisites for this procedure.
1 Open a command line interface session to the Primary ECM
Security Server through the serial port with the nortel account.
2 Switch user to the root account by typing SU and press <enter>.
Nortel Communication Server 1000
Linux Platform Base and Applications Installation and Commissioning
NN43001-315 02.09
29 October 2008
Copyright © 2007–2008 Nortel Networks
.