Filter
Top Products
38 Chapter 2 Installing option cards in the Nortel VPN Router 1100
NN46110-313 02.01
10 Attach an antistatic wrist strap (not included with the VPN Router 1100
shipment).
11 Remove the blank card bracket (or the option card that you are replacing)
from the slot.
12 Install the new option card.
Press the card all the way into the PCI connector on the motherboard.
13 Carefully slide the chassis cover onto the base, and secure it with the four
screws.
14 Attach the bracket of the new option card to the front panel with two screws.
15 Connect the cables to the system ports and to the option card ports.
16 Plug the power cord into the AC power outlet.
17 Plug the external power supply into the port labeled DC Input on the back of
the VPN Router 1100.
Caution: Risk of equipment damage
Electrostatic discharge can damage VPN Router 1100 components.
Caution: Risk of equipment damage
If you must remove an ADSL option card from slot 3 (Figure 14 on
page 37), lift the free end of the card so that the card is at a slight angle,
and then carefully pull it up and out of the slot so that the card clears the
connector of the adjacent slot 2. If you damage components on the
underside of the ADSL interface card, the card does not work.
Caution: Risk of equipment damage
To prevent stress damage to components on the underside of the ADSL
option card when you install that card in slot 3 (Figure 14 on page 37),
hold the card at a slight angle and insert it into the connector so that the
card clears the connector of the adjacent slot 2. If you damage
components on the underside of the ADSL interface card, the card does
not work.