Filter
Top Products
Operation, administration, and maintenance (OAM) features 2-89
Planning and Ordering Guide—Part 1 of 2 NTRN10AN Rel 12.1 Standard Iss 1 Apr 2004
WAN facility
Table 2-15 on page 2-89, lists facility parameters supported by the
2xGigE/FC-P2P WAN interface.
Table 2-15
2xGigE/FC-P2P WAN port signal attributes
Signal Attribute Definition Values
(See Note 1)
Access
(see Note 2)
RATE
(Basic rate)
Is used to indicate the basic rate assigned
to that facility.
None,STS1, STS3C,
STS12C, STS24C
R/O
PROVUNITS
(Bandwidth units)
Is used to indicate the number of
provisioned bandwidth units in the
SONET/SDH transmit direction. The unit
is specified by the RATE attribute.
Possible values when VCAT=ENABLE
are 0..7 (when RATE is STS3c) or 0..21
(when RATE is STS1).
Possible values when
VCAT=DISABLE are 0 or 1.
Possible values when
VCAT=ENABLE are 0..7
(when RATE is STS3c) or
0..21 (when RATE is STS1).
R/O
ACTUALUNITS
(Units carrying traffic)
Is used to indicate the number bandwidth
unit actually carrying traffic in the
SONET/SDH transmit direction.
Possible values when
VCAT=DISABLE, or
VCAT=ENABLE and
LCAS=DISABLE are either 0
or PROVTXUNITS. It will
return UNKNOWN is the card
is not present in the shelf
R/O
MAGICNUM
(Magic number)
(See Note 6)
Enables or disables the use of a magic
number to distinguish between two peers
and detect error conditions. Can be used
to determine whether trying to establish a
link with one self.
Disable
(See Note 3)
R/O
FCS
(Frame checksum
size)
(See Note 6)
Size of the FCS to be used to transmit
packets.
0, 32
(See Note 4)
R/W
LCM
(Link connectivity
monitor)
(See Note 6)
Is used to control the Link Connectivity
Monitor functionality.
Disable
(See Note 3)
R/O
MAPPING
(Mapping protocol)
(See Note 6)
Client signal to SONET mapping protocol GFP-F (default when LAN
facility is Ethernet),
GFP-T (default and only
option when LAN facility is
Fibre Channel)
R/W
MODE
(Mode)
Identifies if the port operates in SONET or
SDH mode.
Sonet, SDH R/O
VCAT
(Virtual
Concatenation)
Indicates if Virtual Concatenation is
enabled or not on this port. Can only be
edited if there are no cross-connections.
Enable, Disable
(See Note 5)
R/W