Filter
Top Products
6/28/2007 page 111 of 145
Set Flow Control
Command Name
port set flowcontrol
Description Enable or Disable flow control (typically refers to 100Base). When
enabled a pause frame will be sent to help control the flow.
Syntax port set flowcontrol <port-no><enable | disable>
Parameters
port-no
port number (1 ~ 12)
enable | disable
Flow Control enable or disable
Examples
N-TRON/Admin#[1]> port set flowcontrol 6 enable
NOTES Check whether port-no is in the valid range. (1 ~ 12)
Set Name
Command Name
port set name
Description Changes the name of the port. This change will only be visible in the CLI.
Syntax port set name <port-no><name>
Parameters
port-no
port number (1 ~ 14)
name
A string that describes the port
Examples
N-TRON/Admin#[1]> port set name 6 waterplant
NOTES This will be reset if you change a slot configuration.
Set PVID
Command Name
port set pvid
Description Set a port’s VLAN-ID.
Syntax port set pvid <port-no><pvid-number>
Parameters
port-no
port number (1 ~ 14)
pvid-number
The VLAN-ID number of the VLAN that this port will be a member of
Examples
N-TRON/Admin#[1]> port set pvid 6 2
NOTES A port can be a member to several VLANs, but can only have one PVID
Set Backpressure
Command Name
port set backpressure
Description Enables or disables backpressure on a given port. This is normally used on
10Base setups and is a controlled by the hardware.
Syntax port set backpressure <port-no><enable | disable>
Parameters
port-no
port number (1 ~ 12)
enable | disable
Backpressure enable or disable
Examples
N-TRON/Admin#[1]> port set backpressure 6 enable
NOTES Check whether port-no is in the valid range. (1 ~ 12)
Set Intruderstate
Command Name
port set intruderstate
Description Enables or Disables the intruder log.
Syntax port set intruderstate <enable | disable>
Parameters
enable | disable
Enable or disable the intruder log
Examples
N-TRON/Admin#[1]> port set intruderstate enable
NOTES This must be enabled for the intruder log to log anything.