Filter
Top Products
6/28/2007 page 115 of 145
Create Trunk
Command Name
trunk create
Description To create a trunk. A trunk is used to get more bandwidth to withstand high
traffic.
Syntax
trunk create <port-list> [-name <trunk-name>]
Parameters
port-list
Port numbers to be added to the trunk.
trunk-name
Name given to a trunk
Examples
N-TRON/Admin#[1]> trunk create 4-7 –name trunk1
NOTES RSTP must be disabled in order to use Trunking. Only 1 trunk can be
created per switch. A maximum of 4 ports can be in a trunk. All trunk
ports must be at the same speed and duplex mode. If a port is not linked,
there could be difficulty matching similar speed and duplex mode. It is best
to hard code speed and duplex mode for each trunking link, at both ends.
Delete Trunk
Command Name
trunk delete
Description To delete the trunk .
Syntax
trunk delete
Parameters
Examples
N-TRON/Admin#[1]> trunk delete
Trunk has been deleted.
NOTES
Show Trunk Information
Command Name
trunk show
Description To show all the trunks information.
Syntax
trunk show
Parameters
None
Examples
N-TRON/Admin#[1]> trunk show
------------------------------------------------
| TRUNK NAME | TRUNK PORTS | TRUNK STATE |
------------------------------------------------
| trunk1 | 3-5 | DISABLE |
------------------------------------------------
NOTES