Filter
Top Products
6/28/2007 page 98 of 145
System Configuration Commands
Set Mode IP config
Command Name
system set modeipconfig
Description To set the IP address mode of the system
Syntax system set modeipconfig <manual|dhcp|bootp>
Parameters
manual
Uses a static IP address scheme (default mode)
dhcp
Pulls an IP address from a DHCP server on the LAN
bootp
Pulls an IP address from a Bootp server on boot up
Example
N-TRON/Admin#[1]> system set modeipconfig dhcp
NOTES Bootp is an older version of DHCP, DHCP is recommended for a
dynamic address scheme.
Set IP/Subnet/Gateway Addresses of the system
Command Name
system set ip
Description To set the IP address of the system
Syntax system set ip <IP-address> <subnet>[ <gateway>]
Parameters
IP Address
The IP address of the system in dotted decimal notation
Subnet
The subnet of the above specified IP Address
Gateway
The gateway address of the system.
Example
N-TRON/Admin#[1]> system set ip 10.1.1.158 255.0.0.0
N-TRON/Admin#[2]> system set ip 10.1.6.150
255.255.255.0 10.1.6.150
NOTES The IP address should be a valid IP address (excluding Class D & Class
E type)
Get IP Address of the system
Command Name
system get ip
Description To display the IP/Subnet/Gateway addresses of the device
Syntax
system get ip
Parameters
None
Example
N-TRON/Admin#[1]> system get ip
NOTES
Set System Name
Command Name
system set sysname
Description To set the system name
Syntax system set sysname <Name-of-the-system>
Parameters
Name-of-the-system
The system name to be used
Example
N-TRON/Admin#[1]> system set sysname N-Tron
N-TRON/Admin#[2]> system set sysname “N-Tron Switch”
Notes Please ensure to use “ “ for supplying arguments with spaces
Get System Name
Command Name
system get sysname
Description To display the name of the system
Syntax
system get sysname
Parameters
None
Example
N-TRON/Admin#[1]> system get sysname
System Name : N-TRON Switch
Notes