Filter
Top Products
29
Set Up the Hardware
Start the system, then connect the external source signal to the House
Sync connector (BNC) of the Quadro G-Sync II option card.
The Quadro G-Sync II supports the following external
synchronization signal types:
TTL (3.3 volt level)
Composite Bi-level (NTSC or PAL sources use bi-level composite
signals)
Composite Tri-level (HDTV sources commonly use tri-level
composite signals)
2. Check the LED on the connector panel.
A green LED means the hardware has detected the timing signal,
and you can proceed to the next step
An occasional red fl ash is OK.
A red LED means the hardware can’t detect the timing signal.
Check the signal source and correct the problem before
proceeding.
Sync Source
Server
NVIDIA Quadro G-Sync II
Connector Bracket
1.
NVIDIA Frame Synchronization Under Linux