Filter
Top Products
30
Set Up the Software
Basic Genlock Setup
Go to the nvidia-settings frame lock panel.
Click Add Devices, then add the X Server that contains the display
and G-Sync II cards that you want to sync to this external source.
An X Server is typically specifi ed in the format:
system:m
For example: mycomputer.domain.com:0 or localhost:0
After adding an X Server, the G-Sync Devices section shows the
X server name, the graphics card attached to the X server, and the
displays attached to the graphics board.
Check the Server check box for one of the displays connected to the
system in order to designate the
system as the frame lock server.
Click the Use House Sync if
Present checkbox.
Click Enable Frame Lock.
The display device(s) may take a
moment to stabilize. If it does
not stabilize, you may have
selected a synchronization signal
that the system cannot support–
click Disable Frame Lock and then check the external sync signal.
Note: Any time you modify the genlock settings (for example, by clicking Use
House Sync if Present or Add Devices), you must fi rst click Disable
Frame Lock to disable synchronization.
1.
2.
3.
4.
5.
NVIDIA Quadro G-Sync II User Guide