Filter
Top Products
76 Microline 390/391 Turbo
|
Explanations of Menu Items
Refer to “Using Your Printer, Menu Mode, Menu Settings Table” for an overview of the menu structure.
Auto CR (IBM). If you want the printer to automatically add
a carriage return when a Line Feed is received at the end of a
line, change the setting to Yes.
Auto LF. If your printout is consistently double spaced,
select No; if it overprints, select Yes.
Auto Feed XT (Epson). If your system uses pin 14 of the
parallel interface to control automatic line feed, change the
setting to Valid.
Auto Select. If you always use the same Top of Form position,
change the setting to Yes.
Bottom Margin. Change to Invalid if you want the printer to
ignore the bottom margin setting.
!
Caution!! This can cause loss of data and damage the
printhead by allowing printing without paper.
Centering Position. Used to limit printhead travel when
printing narrow columns.
Select Mode 1 for the narrow carriage printer.
Select Mode 1 or Mode 2 for the wide carriage printer.
Character Set. Choose IBM Set I or IBM Set II
Code Page. Choose the Code Page character set you wish to
use: USA (IBM 437), Canada French (IBM 863),
Multilingual (IBM 850), Portugal (IBM 860), Norway (IBM
865), BRASC II, or Abicomp.
Emulation Mode. Choose the printer emulation.
Form Tear-Off. Choose 500 ms, 1 sec, or 2 sec to turn the
Form Tear-Off feature on and to set the time interval for the
printer to wait before advancing the paper.
Graphics. Change to bi-directional graphics for faster
printing. Optimize the registration using the Print
Registration setting in the Menu.
Graphics Speed. Change to High for faster printing when
optimum print quality is not an issue.