Filter
Top Products
20 ML3320/21
Language Set. Replaces certain standard symbols with
special characters used in foreign languages.
Line Spacing. Change to 8 lpi to print more lines on a page.
Operator Panel Function. Change to Limited Operation to
deactivate the PRINT QUALITY and CHARACTER PITCH
buttons. This prevents these from being changed via the
control panel when multiple people are using the printer.
Page Length. Selects the length of the paper you are using.
Page Width (Model 3321 only). Change to 8" to print on
letter-size paper.
Paper Out Override. Senses when less than 1" (25 mm) of
paper remains, and stops printing. Change to Yes to override
the sensor. Caution! This can cause loss of data and damage
the printhead!
Pin 18. Sets the signal on pin 18 to +5 volts or to open.
Pitch. Choose the character width, in character per inch (cpi).
Print DEL Code (ML). Change to Yes if you wish to print
the DEL code (decimal 27) as a solid box.
Print Mode. Choose the quality and speed of printing.
Print Registration. Change the setting as required to obtain
the best registration for bidirectional printing.
Print Suppress Effective. If your system uses the DC1 and
DC3 codes for something other than the print suppress mode,
change the setting to No.
Proportional Spacing. Change the setting to Yes to engage
proportional spacing of characters.
Receive Buffer Size. Selects the amount of memory devoted
to holding received data. Choosing 1 Line will tie up your
computer while printing, but if you abort the print job, the
printer will stop much sooner.
Reset Inhibit. Select Yes to prevent your software from
resetting your printer's settings.
SI Select Pitch, 10 cpi (IBM). Sets the pitch to be engaged
when the printer control panel is set for 10 cpi and the SI
command is received.
SI Select Pitch, 12 cpi (IBM). Sets the pitch to be engaged
when the printer control panel is set for 12 cpi and the SI
command is received.
Size. Change to Double for double width and height printing.
3320hlp3.pm6 13/03/96, 16:0120