Filter
Top Products
could damage / destroy the printhead, platen, and ribbon.
4. Press and hold the SHIFT switch while pressing the SEL switch.
5. The MENU lamp will light. If the printer was selected, the SELECT lamp will light.
When in Menu Mode, the functions printed below the operator panel switches are active.
6. Press the PRINT switch.
7. The Menu will print.
8. Press EXIT to exit Menu Mode.
For more information regarding the menu, please refer to the Printer Handbook.
Reset Menu to Factory Defaults
CAUTION:
Once the menu has been reset, all customized menu settings will be lost.
Always print the menu before resetting the printer to factory defaults.
To reset the menu to factory default settings:
1. Before resetting the Menu, Okidata STRONGLY RECOMMENDS printing the Menu.
Printing the Menu provides a reference of customized settings.
When the Menu is reset, all customized settings are LOST.
2. Power off the printer.
3. Press and hold SEL and LF while powering ON the printer.
Limited Operation
General Information
One of the menu selections that may be set by the end user is the operator panel function. This is found
in the Set-up Group of the menu. Operator Panel Function is an item in the Set-up Group. This item may
be set to either Full Operation or Limited Operation.
If the Operator Panel Function is set to Limited Operation the menu cannot be accessed and the
operator panel switches listed below are not active.
1. Print Quality
2. Character Pitch
The Operator Panel Function item is frequently set to Limited Operation on networks or other areas
where many users share a printer. Limited Operation prevents the printer settings from being changed.
This item cannot be changed through the OKISMART software. However, the print quality and character
pitch may be set through your software application packages.
Procedure
To return the printer to Full Operation, you must modify the menu.
CAUTION:
Determine the preference of the end user regarding this feature. If the printer is on a network, do not
reset this item without discussing the change with the network supervisor.