Filter
Top Products
E-12 Section 1
Set the Top of Form
The red line ( ) on the
clear plastic paper
shield shows the
baseline of the current
printing position to help
you place the top of
form.
To set the Top of Form:
SEL
SEL
LF
FF/LOAD
TEAR PARK QUIET
SHIFT
Micro Feed
Down
TOF
Micro Feed
Up
EXIT
GROUP
SET
PRINTITEM
MENU
1. Make sure the printer is deselected (SEL light off—if
necessary, press SEL ( ) button to deselect printer).
2. Hold down the SHIFT button ( ) and press:
• FF/LOAD button ( ) to move the paper up in micro
increments (TOF lower on page), or
• LF button ( ) to move the paper down in micro
increments (TOF higher on page).
When you’re done setting the TOF, press the SEL button
( ) to reselect the printer.
Temporarily Changing the Print Start Position
To place the print start position lower for one page only:
1. Press SEL to deselect the printer.
2. Keep pressing the LF button until the red line on the
paper shield reaches the new position.
Resetting Top of Form to Default
To reset the Top of Form to the factory default, turn off
the printer, then hold down the QUIET and PARK
buttons while turning the printer back on.
SEL
SEL
LF
FF/LOAD
TEAR PARK QUIET
SHIFT
Micro Feed
Down
TOF
Micro Feed
Up
EXIT
GROUP
SET
PRINTITEM
MENU
Top of Form interacts with the Forms Tear-Off setting.
For more information, see Continuous Forms: Setting
Forms Tear-Off and Top of Form.