Filter
Top Products
Using Your Printer E-33
If you have problems setting the Top of Form high
enough on the page when using Forms Tear Off, see
“Problem Solving.”
Paper Park Feature
If you have continuous-form paper loaded and you wish
to switch to another paper path, first tear off the printed
pages, then press the PARK button. The continuous-form
paper will immediately retract from the paper path.
PARK
PRINT
Switching Paper Paths
To switch to single-sheet feed:
1. Tear off any printed pages, then press PARK.
2. Swing the wire guide up into the paper separator, and
swing the separator upright.
3. Move the paper lever to “TOP.”
4. Load single sheet paper.
To switch to continuous-form feed:
1. Press FF/LOAD to remove single sheet from paper
path if needed.
2. Lower the paper separator and swing the wire guide
out.
3. Move the paper lever to “REAR” or “BOT,” as appro-
priate.
4. Press FF/LOAD.
When you switch paths, the printhead travels and
gently fires pins to sense paper thickness and set the
gap.