Filter
Top Products
30
End
Start
Time
Soak Time Soak
Z step
• To memory load the cycle parameters, follow the procedure indicated below
• Select the required tecnical unit or electrical parameters
• Select the required decimal point position
• Press
<SHIFT> + <TIME>
keys to enter the cycle set-up procedure obtaining the following indication
Ti
me
0h
0
m
50
s
related to the "time" in hours, minutes and seconds. The maximum setting is limited to 5 hours 33 minutes 20 seconds
(20.000 seconds)
• Press the
<START>
key to obtain the following indication:
St
ar
t
0
.
0
m
V
• Press the <▲> and <▼> cursors to set the "Start" level of the cycle
• Press <
ENTER
>+<
START
> keys to memory store the new value
• Press the
<END>
key to obtain the following indication:
E
n
d
100
.
0
m
V
• Press <▲> and <▼> cursors to set the "end" level of the cycle
• Press <
ENTER
>+<
END
> keys to memory store the new value
• Press the
<STEP>
key to obtain the following indication:
St
ep
1
.
0
m
V
• Press <▲> and <▼> cursors to set the size of each individual step. To have a continuous ramp set the minimum
possible value (e.g. = 0.1)
• Press <
ENTER
>+<
STEP
> keys to memory store the new value
• Press the
<TIME>
key to obtain the following indication:
Ti
me
0h
0
m
50
s
• Press <▲> and <▼> cursors to set the required ramp time - max. 5h-33m-20s (20000 seconds)
• Press <
ENTER
>+<
TIME
> keys to memory store the new value
• A setting of 0h-0m-00s allows a manual step advance each time the <
AUTORAMP
> key is pressed.
• Press the
<SOAK>
key to read the following indication:
S
oa
k
0h
0
m
50
s
• Press <▲> and <▼> cursors to set the waiting time (or soak time). If the setting is 0h-0m-0s the waiting or soak time
is excluded