Filter
Top Products
Manual No. 25-ULPNMU01-01 LPN1736 Omni-Directional Laser Scanner
Appendix A
Start / Stop Programming Bar Code
Opticon scanners are preprogrammed at the factory with default settings representing the
settings most commonly used by our customers. In most applications, the scanner will
work right out of the box without the need for additional programming.
If desired, you can change or program the settings of the scanner by reading special
programming bar code symbols. These special bar codes are contained in this manual.
In order to read these special programming bar codes, the scanner must first enter the
“programming mode”. This is accomplished by scanning the following bar code
symbol:
[[
Start/Stop Programming Mode
Scanning this programming bar code puts the scanner into the programming mode. The
scanner will beep continuously indicating that it is in programming mode. In this mode
the scanner will only read special programming bar codes. It will not read regular bar
codes.
Page 142