Filter
Top Products
28 Packard Bell oneTwo M3350 / oneTwo M3351 / oneTwo L5350 / oneTwo L5351 Service Guide
Removing the Rear Cover
1. Remove the computer stand by following the procedure described on page 26.
2. Remove the I/O cable cover and the rubber feet by following the procedures described on page 27.
3. Use a flat screwdriver to carefully pry loose the rear cover from the front bezel.
The picture below shows the location of the plastic sna
ps securing the rear cover to the front bezel.
4. Toggle the cover from left to right to loosen its hold on the front bezel, then detach the rear cover.
Removing the I/O Cable Plate
1. Remove the rear cover by following the procedure described in the previous section.
2. Push the latch to disengage the I/O cable plate from the main chassis.