Filter
Top Products
18
Menu settings
$ Dial memory
Menu-6 Output-2
(Initial setting: P1)
This setting selects which pan-tilt head system is to be controlled by this adapter when this
adapter is in Direct mode.
The pan-tilt head system connected to the RS-232C or RS-422 P1 connector is
controlled.
P1
P2
P3
P4
P5
The pan-tilt head system connected to the RS-232C or RS-422 P2 connector is
controlled.
The pan-tilt head system connected to the RS-232C or RS-422 P3 connector is
controlled.
The pan-tilt head system connected to the RS-232C or RS-422 P4 connector is
controlled.
The pan-tilt head system connected to the RS-232C or RS-422 P5 connector is
controlled.
This adapter’s dial memory function enables up to 5 specific
telephone numbers to be stored.
ORegistering a telephone number
1. Enter the number using the operating keys on this
adapter.
2. While pressing the key, press one of the dial memory
registration keys from (M1) through (M5) into
which the number is to be entered.
3. “Writing Memory 2” (2 is the dial memory number)
appears on the LCD panel and the telephone number is
stored.
51
#
OUsing a dial memory to make a call
1. Press the key ( i ).
2. The dial memory number (M1 to M5) entered appears on
the LCD panel.
If a telephone numbers has not been registered for the
dial memory number, the LCD panel display will be blank.
3. Each time the key ( i ) is
pressed, the dial memory number is switched.
4. Press the key to initiate the connection.
START
STOP#RECALL
STOP#RECALL
This setting selects which connector is to be used for the controller when this adapter is in Direct mode.
TO RCB/PC connector (PC used for control)
PAN/TILT CONTROL IN connector (control panel used for control)
RS-232C
RS-422
This setting selects which connectors are to be used for the pan-tilt head systems.
The RS-232C CONTROL OUT connectors are used.
The RS-422 connectors cannot be used in conjunction with these
connectors.
The RS-422 CONTROL OUT connectors are used.
The RS-232C connectors cannot be used in conjunction with these
connectors.
RS-232C
RS-422
Menu-4 Input
(Initial setting:RS-232C)
Menu-5 Output-1
(Initial setting: RS-422)
The following items are only displayed when this adapter is in Direct mode
The following item is only displayed when this adapter is in Rx mode or Direct mode
OErasing a dial memory
1. Press the key ( i ) to erase the
number displayed on the LCD panel.
2. While pressing the key, press one of the dial memory
registration keys from (M1) through (M5) which is
to be erased.
3. “Writing Memory 2” (2 is the dial memory number)
appears on the LCD panel and the telephone number is
erased.
51
#
START#CLEAR