Panasonic AW-SW350E Switch User Manual


 
31 (E)
ENGLISH
30 (E)
Click the RAM radio button or RAM+ROM radio button to select the type of memory
in which the data will be saved. (Fig.13) If RAM is selected, the image data is saved
only in the frame memory and so it cannot be used after the AW-SW350 power has
been turned off and back on again. If RAM+ROM is selected, the image data is
saved in the flash memory and so it can be used after the AW-SW350 power has
been turned off and back on again. However, the actual transfer takes longer than
when RAM is selected.
Click the Write USB button to start transferring the image data. After the completion
of the transfer, monitor the AW-SW350's PGM output and check that the image data
has been transferred. (Fig.14)
6
5
When images could not be transferred
If an error resulted or images could not be transferred because a cable was connected or
disconnected, turn off the switcher's power and exit the application programme. Then turn
the switcher's power back on again and start up the application again.
Status after power has been turned off and back on again
Transfer time
RAM Transferred image data cannot be used Approx. 10 sec.
RAM+ROM Transferred image data can be used Approx. 60 sec.
The transfer times given in the above table are approximations only. The actual time
taken will depend on the performance of the host computer.
Fig.13 Memory selection
Click the
button
AW-SW350
programme output
Fig.14 PGM check