Filter
Top Products
18
How to Use the On Screen Menu (continued)
• Press the ADJUST button (J page 13, ) to open the
picture/volume adjusting menu.
• To clear the display, press the ADJUST button again,
press the MENU button or leave it idle for 10 seconds.
• Only adjustments that appear on the screen can be
adjusted.
• The display always appears in the same screen
location.
• This is the SHARPNESS H/V mode display.
• It disappears after 2 minutes of inaction.
• Displayed when setting SHARPNESS H in 3D mode.
• Use the menu to open and set up functions.
• When “FUNCTION DISPLAY” (J page 36) is set to
“ON1” or “ON2”, pressing any of the “FUNCTION1” to
“FUNCTION5” buttons displays the item and the
status of the item for the respective FUNCTION.
• This display disappears after 2 seconds of inaction.
• “XXXXX” indicates operating status (J page 38,
“Functions and operating status displayed on screen
when FUNCTION buttons are pressed”).
• A white skeleton bar meter indicates the audio level
for SDI signals. When 3D mode is set to SIMUL, audio
from the SDI signal input via SDI1 is always used.
• You can switch the level display on/off and set the
number of displayed channels using the menu
(J page 42, “AUDIO”).
• The 0 dB line and channel display can be switched
on/off from the menu (J page 42, “AUDIO”).
Note:
When SDI2 and another input (except for a
combination of SDI1 and SDI2) are used for the split
screen display, TIME CODE and audio level meter
display will not function. In this case, use SDI1.
Picture/volume adjusting menu
9
Sharpness display
FUNCTION display
F1:MARKER
F2:CROSS HATCH
F3:BLUE ONLY
F4:TIME CODE
F5:LEVEL METER
XXXXX
Audio level meter display
11
33
55
77
22
44
66
88
Channel
display
Level
display
0 dB line
BT-3DL2550PE(VQT2U10)_E.book 18 ページ ２０１０年７月８日 木曜日 午後２時１２分