Panasonic BT-LH80WP Computer Monitor User Manual


 
23
FUNCTION
The underlined values are factory preset setting values.
Sub menu Settings Explanation
FUNCTION1 - 3 BLUE ONLY
SD ASPECT
1
2
WFM
MARKER
1
3
PIXEL TO PIXEL
4
PIXEL POS.+
5
PIXEL POS.–
5
FOCUS-IN-RED
4
7
ZEBRA
REAR TALLY
6
CROSS HATCH
MONO
1
UNDEF
(Factory preset
setting
FUNCTION1:
WFM
FUNCTION2:
PIXEL TO PIXEL
FUNCTION3:
FOCUS-IN-RED)
Used to select the functions to be assigned to individual buttons
[FUNCTION1] to [FUNCTION3] (front-panel buttons).
<BLUE ONLY>
Used to cut the red and green signals. You can check the hue (PHASE)
and depth of color (CHROMA). This is switched between ON/OFF by
pushing the button.
<SD ASPECT>
Used to switch between “16:9” and “4:3”.
<WFM>
Used to display the waveform display screen.
<MARKER>
Used to display the marker.
<PIXEL TO PIXEL>
Used to switch the screen display between input size and display
size.
<PIXEL POS.+>
During PIXEL TO PIXEL display, used to move the signal display
position clockwise and display it.
<PIXEL POS.–>
During PIXEL TO PIXEL display, used to move the signal display
position counterclockwise and display it.
<FOCUS-IN-RED>
Used to highlight in red the section of the image that is being
focused.
<ZEBRA>
Used to set the zebra display ON or OFF for the camera.
<REAR TALLY>
Used to set the rear tally ON or OFF.
<CROSS HATCH>
Used to display a cross hatch.
<MONO>
Used to switch the display between color and black-and-white.
<UNDEF>
Undefined.
FUNCTION
DISPLAY
8
ON1
ON2
9
OFF
Used to display the functions assigned from [FUNCTION1] to
[FUNCTION3] (buttons on the front panel). The button action can also
be selected (1-touch, 2-touch, OFF).
<ON1>
Function display and function operation can be performed with one
touch.
<ON2>
Function display and function operation can be performed with two
touches.
<OFF>
Function not displayed.
If a FUNCTION button is pushed during the picture adjusting knobs display, the picture adjusting knobs display will
be cancelled and the FUNCTION operation cannot be executed.
1 The control settings do not operate during GPI operation.
2 If these settings are changed, the menu settings will also change.
3 Not displayed when 16:9, 4:3, BACK and CENTER are all OFF in the MARKER menu settings.
4 SD ASPECT cannot be switched when PIXEL TO PIXEL is ON during SD display.
5 PIXEL POSITION is not backed up. It is always CENTER when the power supply is switched ON.
6 Only enabled when TALLY control from the camera is ON.
7 During FOCUS-IN-RED operation, the detection sensitivity can be changed with the FOCUS-R knob.
The setting range is from 0 to 30, with 30 the most sensitive detection.
8 The operating status is displayed regardless of the ON/OFF setting.
9 The function displayed with the ON2 setting can be operated with a button only during the time that it is
displayed.
Main Menu (continued)