Filter
Top Products
10-7
10.2. Reassembly Instructions
10.2.1. Attention when CF-74 series is repaired
• Please execute writing BIOS ID when you exchange the Main Board.
• You cannot reuse the Conductive Clothes and the heat dissipating parts such as Sheet and Rubber. Use new parts.
10.2.2. Setting the LCD Unit and the
Inverter
1. Fix the W-LAN PCB L and R to the LCD Rear Cabinet
using the two Screws <N18>.
2. Attach the Inverter with the Inverter Case to the LCD Rear
Cabinet.
3. Set the LCD Unit to the LCD Rear Cabinet.
4. Connect the LCD/INV. Cable to the Connector on the
Inverter.
Screws <N18>: XQN17+BJ6FJ
n
nn
n Arranging the W-LAN L and R Cable
LCD/INV. Cable
Inverter
Inverter
Case
LCD Unit
<N18>
<N18>
LCD Rear Cabinet
W-LAN PCB L
W-LAN PCB R
W-LAN Antenna L PCB W-LAN Antenna R PCB
LCD Rear Cabnet
Attach the Tape to hold the Cable.
Pass the Cable
through the notch
and lead it downward.
Pass the Cable between
the boss and rib.
Pass the Cable through the notch
and lead it downward.
Lead the Cable along the surface.
Attach the Tape to each of the Cables.
(Avoid overlapping.)
Avoid overlapping of the Cables
(all the way).
Pass the Cable through the notch.
(Avoid running over the ribs.)
Pass the Cable through the notch.
(Avoid running over the ribs.)