Filter
Top Products
GN Series Hardware Manual
3.8 Connecting the System to the Power Supply
33
3.8 Connecting the System to the Power Supply
CAUTION
• Attach the power cable last!
• Before using your system, you should first become familiar with the system
components and check that everything is connected properly.
3.8.1 DC Power Plug
The GN panels are delivered with a DC power plug (3-pin Phoenix connector), which you
need to prepare.
☞
NOTE
The length of the wires connected to the DC power connector may not exceed
10m.
1
2
3
DC power plug
1 Cover for terminal screws
2 "-" wire terminal
3 "+" wire terminal
1.
2.
3.
Procedure
1. Cut the two isolated wires [AWG18 (Ø up to 1mm
2
)] to the required length
2. Strip each end 5 – 7mm
7mm
3. Apply wire end ferrules
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: info@ctiautomation.net