Filter
Top Products
Cleaning the Unit
24
3
Use the roller cleaning paper
(KV-SS03) to remove the dirt from the
surfaces of all rollers.
≥ When wiping off the dirt, hold the rollers
to prevent them from rotating. Wipe the
rollers all the way around from one end to
the other in the directions of the arrows
shown on the diagram to the right.
≥ Perform the retard roller cleaning only in
the left direction. If cleaned in the right
direction, the roller may slip out of the
proper position.
≥ When cleaning the rollers in the back of
the bottom image sensor cover (rollers of
part A), do not touch the tip of the plastic
pointer (black) in the back of the unit.
Set the paper path selector as shown
below.
Warning:
When the tip of the pointer is raised, the tip
may cause an injury.
≥ The image sensor covers may be very hot
after scanning a lot of documents.
Never touch the image sensor covers or
surroundings directly.
For roller cleaning, pull the belt in the direction of
the arrow to rotate the rollers.
Pointer
≥ Wipe in the direction of the arrows.
Paper feed roller
Belt
Retard rollers
Left side view
Other rollers Retard rollers
Separation roller
A
Free rollers
Free rollers
Free rollers
Drive rollers
Drive rollers
Drive rollers
Conveyor rollers Free rollers
Image sensor covers
Paper path
selector
The paper path selector is located on
the left side of the scanner.
Pointer
Paper path
selector