Filter
Top Products
65
Correct image defects (blemishes) such as scratches
Image defects (blemishes) such as scratches can be corrected in the following method.
Step 1
Press the [SET] button after moving the cursor onto
"PIX OFF" on the "SPECIAL SETUP" page.
→ The "PIX OFF" page will be displayed.
Step 2
Press the [SET] button after selecting a number (1 – 16)
to be registered as a blemish compensation point.
→ The blemish compensation point setting window will
be displayed.
Step 3
Press the [SET] button after moving the cross cursor (+)
onto a center point of the desired blemish point using
the [Left], [Right], [Up] and [Down] buttons.
→ The designated blemish will be compensated and
the blemish compensation point will be registered.
The "PIX OFF" page will be displayed. An asterisk
(*) will be displayed next to the respective number
when registered. Coordination number of the regis-
tered point will be displayed.
Note:
To delete the registered blemish compensation
point, move the cursor onto the respective blemish
compensation number on the "PIX OFF" page and
press the [SET] button. When the blemish compen-
sation point setting window is displayed, press the
[Left] and [Right] buttons for 2 seconds simultane-
ously. The "PIX OFF" page will be displayed. When
the blemish compensation point is deleted, an aster-
isk (*) next to the number will disappear.
**PIX OFF**
1 2 3 4
5 6 7 8
9 10 11 12
13 14 15 16
0000 0000
RET TOP END