Filter
Top Products
13[For assistance, please call: 1-800-272-7033]
Useful Information
Resetting an adaptor
Normally an adaptor does not need to be reset, however, you may need to reset an
adaptor if:
• You are concerned that another adaptor may have been accidentally
registered to your master. (For example, the adaptor of someone who lives
in the same apartment building as you.)
• An error occurs while registering a terminal to the master.
• You are registering an adaptor
Note
• Resetting a terminal erases its registration to the master. It must be registered
to the master again in order to be used.
• If the master is reset, all terminals must be registered to the master again in
order to be used.
Follow the procedure below to reset an adaptor.
1. Press the FACTORY DEFAULT RESET button on the adaptor for about 3
seconds.
• The adaptor’s indicators will begin flashing.
2. Once the adaptor’s indicators stop flashing, the adaptor has been reset.
• Do not disconnect or unplug the AC cord for 30 seconds.
BL-PA100KTA_OI.book Page 13 Thursday, March 16, 2006 4:17 PM