ENGLISH-21
Getting started
20-ENGLISH
DIN 8-pin
(male)
Computer for
control use
Computer
Computer
Example of connecting to computer
Monitor
NOTE:
BIt is better to shut down the computer before turning off the MAIN
POWER switch of the projector.
BDo not input the signal to the RGB2 IN/RGB1 OUT connector when the
RGB2 SELECT item in the OPTION1 menu is set to OUTPUT. (Refer to
page 42.)
Insert the lithium battery which is
supplied with the remote control
unit, making sure that the polarities
are correct.
#While pushing the battery
holder tab to the right, pull out
the battery holder.
$Insert the battery into the
battery holder so that the +
side is facing upward.
%Insert the battery holder.
Preparation for the remote control unit
Push the tab
Pull out
Match the “+”
surface of the
battery with the
“+” marked side of
the battery holder.
Back side
NOTE:
BDo not drop the remote control
unit.
BKeep the remote control unit
away from liquids.
BRemove the battery if not using
the remote control unit for long
periods.
BUse only CR2025 batteries as
replacement batteries.
NOTE:
BIf the remote control unit is
held so that it is facing directly
in front of the front or rear
remote control signal
receptors, the operating range
is within approximately 7 m
(23´) from the surfaces of the
receptors. Furthermore, the
remote control unit can be
operated from an angle of ±30°
to the left or right and ±15°
above or below the receptors.
BIf there are any obstacles in
between the remote control
unit and the receptors, the
remote control unit may not
operate correctly.
BIf strong light is allowed to
shine onto the remote control
signal receptor, correct
projector operation may not be
possible. Place the projector
as far away from light sources
as possible.
BIf facing the remote control unit
toward the screen to operate
the projector, the operating
range of the remote control
unit will be limited by the
amount of light reflection loss
caused by the characteristics
of the screen used.
RGB signal cable
(accessory)
RGB signal cable