Filter
Top Products
ENGLISH-37
Adjustments and settings
36-ENGLISH
BRIGHT
This adjusts the darker areas (black
areas) in the picture. Press the H
button if dark areas are too solid (for
example, if hair is difficult to see), and
press the I button if black areas are
too light (grey rather than black).
COLOR
(S-VIDEO/VIDEO/YPBPR only)
Press the H button to make the
color more vivid in tone, and press
the I button to make the color
more pastel in tone.
TINT
(NTSC/NTSC 4.43/YPB
PR only)
This adjusts the flesh tones in the
picture. Press the H button to make
flesh tones more greenish, and
press the I button to make the
flesh tones more reddish.
SHARPNESS
Press the H button to make the
picture details sharper, and press
the I button to make the picture
details softer.
Color Hue Setting (color
temperature)
This is used to adjust the white
areas of the picture if they appear
bluish or reddish.
WHITE BALANCE R/G/B
(RGB only)
This is used to adjust the white
areas of the picture if they appear
colorised. Press the I button to
make the selected color lighter.
AUTO1
The projector automatically
distinguishes between NTSC/NTSC
4.43/PAL/PAL60/SECAM signals.
AUTO2
The projector automatically
distinguishes between NTSC/PAL-
M/PAL-N signals.
TV-SYSTEM AUTO1
[
AUTO2
[
NTSC
[
NTSC4.43
[
PAL
[
PAL-M
[
PAL-N
[
SECAM
TV-SYSTEM
(S-VIDEO/VIDEO only)
Press the H button to make the
selected color stronger.
COLOR TEMP. STANDARD
[
HIGH
[
LOW
NOTE:
BThis should normally be set to
“AUTO1” or “AUTO2”. If the
signal is of such poor quality
that the correct format cannot
be automatically distinguished,
change the setting manually to
the required TV system.
STILL MODE
To reduce flickering of still images (vertical
flicker), set "STILL MODE" to “ON” by pressing
the I or H buttons.
SIGNAL MODE
(RGB/YPBPR only)
This displays the type of signal which is
currently being projected.
Refer to the table on page 58 for details on
each type of signal.
Projecting sRGB-compatible
pictures
sRGB is an international color reproduction
standard (IEC61966-2-1) established by the
International Electrotechnical Commission
(IEC). If you would like the colors in sRGB-
compatible pictures to be reproduced more
faithfully, make the following settings.
##
Press the
FF
or
GG
button to select
“PICTURE MODE”, and then use the
II
or
HH
button to select “NATURAL”.
$$
Press the STANDARD (STD) button on
the remote control unit.
%%
Press the
FF
or
GG
button to select
“COLOR TEMP.”, and then use the
II
or
HH
button to select “STANDARD”.
STILL MODE OFF
[
ON
NOTE:
BsRGB is only enabled when RGB
signals are being input (when LAMP
POWER has been set to “HIGH”).
NOTE:
B
Do not set “STILL MODE” to “ON” when
playing back moving images.