Filter
Top Products
ENGLISH - 41
Maintenance
Care and Replacement
J Before cleaning the projector
Switch off the MAIN POWER switch in proper way and disconnect the mains plug from the mains socket.
Unplug all the cables from the projector.
J Cleaning the outer surface of the projector
Wipe off dirt and dust gently with a soft cloth.
If it is difficult to remove the dirt, soak a cloth in water, wring the cloth well and then wipe the projector. Dry off the
projector with dry cloth.
Do not use petroleum benzine, thinner, any alcoholic solvent, kitchen detergents or chemical clothes. Failure to observe
these may result in altered or damaged surface of the projector.
J Cleaning the lens surface
Wipe off dirt and dust gently with a lint-free cloth.
Make sure no dirt or dust remains on the surface of the lens. It will be enlarged and projected onto a screen.
J Cleaning the air filter
If the air filter is excessively dirty, the internal temperature of the projector increases and may cause
malfunction. Clean the air filter regularly every 100 hours of usage.
1. Turn the projector upside down and place it gently on a soft cloth.
2. Press the tab and slightly slide up the air filter to remove.
3. Vacuum dirt and dust from the air filter.
Do not wash the air filter.
4. Place and slightly slide in the air filter in the air intake port to attach.
Make sure the air filter clicks into the place.
J Replacing the air filter
The air filter should be replaced when cleaning is ineffective and when replacing the lamp unit. A replacement
air filter is provided with a replacement lamp unit, ET-LAX100. Contact an Authorised Service Centre for the
optional air filter.
Cleaning the projector
NOTE:
• Do not use the projector without attaching the air filter.